
A stand-alone adapter between one SpaceWire link and a host MCU on SPI. A Lattice MachXO2 runs the SpaceWire codec and two packet FIFOs in 32 MB of SDRAM, so neither side has to keep up with the other in real time. A 100 nF capacitor sits directly under every FPGA and SDRAM supply pin.

Three Analog Devices Silent Switcher 2 converters on one 6-layer board, locked to a 3-phase oscillator with 10 % spread spectrum or to an external clock. Input pi filter with damping, second-stage output filters, per-rail enable and power-good, and an I²C monitor on every output.

A low-noise amplifier for SDR receivers with a switchable 433.92 MHz SAW filter in front of it. Two GaAs switches route either the wideband path or the filter. RF lines are 50 Ω grounded coplanar waveguide with the solder mask removed, computed by the field solver on the real stackup.

A castellated radio module for MeshCore: Semtech SX1262 with a Skyworks front end at +30 dBm, an extra low-noise amplifier and a discrete LC band-pass in the receive loop, and a 7th-order LC harmonic low-pass with 0.55 dB of loss. The +30 dBm stage is for regions that allow it: in the EU the 868 MHz band allows at most 500 mW e.r.p. (869.4–869.65 MHz).

A hand-held presentation remote that also works as an air mouse: slide control, a virtual laser pointer driven by motion fusion, haptic and RGB feedback. Bluetooth LE or USB HID, charged over USB-C, on a slim stick the size of a commercial presenter.

A full-size Nucleo-144 shield carrying a matrix of 31 × 60 red 0402 LEDs at a 1.75 mm pitch, every one turned 45°. Columns are switched by P-MOSFETs behind decoders, rows are sunk by constant-current drivers. The matrix, lanes and via staircases are all scripted copper.

A stand-alone charger for a two-cell pack on a 100 g drone: a 1.6 MHz synchronous buck with reverse-blocking input, input current limit, safety timer and NTC, plus a cell balancer with per-cell overvoltage cut-off. The current rating comes from the thermal model, not from the datasheet headline.

A software-defined radio: a Zynq-7020 runs Linux and the data path of an AD9361 transceiver, with a switched RX preselector and LNA, a TX gain block to about +20 dBm, 1 GB of DDR3L, gigabit Ethernet and USB. Eight layers, BGAs on both sides. The schematic is complete, the DDR3 is being routed now.
Send the requirements of your board: one sentence or a full spec. You get a fixed price and a date within one working day.